Site leadership and quality · Borescope

Borescope images and records: what QA/QC should keep

Keep, for each examined weld, images that clearly show the inside bead around the circumference, labelled with the weld number, date, inspector and result. Store them so any image can be found from the weld log in seconds. The owner specification sets which welds need images, the acceptance criteria and how long records are kept.

What a usable record contains

Borescope record content (check the owner specification)
ItemWhy
Weld numberThe only reliable link to the log and the map
Date and inspectorWho examined it and when
Images covering the circumferenceOne image of one side does not show the whole bead
Result and reasonAccept or reject against the stated criteria
Equipment IDWhich borescope; for calibration or quality questions
Link to repairIf rejected, the repair weld number and its images

Image quality rules

  • Lighting and focus good enough to judge discoloration, bead width and penetration.
  • The weld number visible in the image or in a fixed file name, not only in someone’s memory.
  • No cropping or editing of images used for acceptance.
  • Same viewing method each time, so images can be compared.
  • Reference images of acceptable and rejectable welds, agreed with the owner, kept for inspectors to compare against.

Check the borescope itself as part of the record. A scratched lens, poor light or a probe that cannot reach the full weld produces images that cannot be judged. Note the equipment used, keep it clean, and replace or repair it when image quality drops, before an owner reviewer rejects a batch of records.

Naming and storage

Use a fixed naming pattern built from system, line and weld number, store images in the folder structure the turnover package will use, and back them up. A borescope image that cannot be found when the owner asks is little better than no image. Link the image reference in the weld log (weld maps and logs).

Where the owner spec decides

Owner specifications for semiconductor gas and chemical lines decide whether every weld or a sample needs borescope examination, the visual criteria (often based on SEMI F81) and the hand-over format. Some require images of sample welds as well as production welds. Retention after handover is also the owner’s call. Ask for these requirements before the first weld.

Sample and coupon welds deserve the same care. Where the owner requires start-of-shift or change-of-setup sample welds, their images show that the setup was right before production welding, and auditors may ask for them alongside the production weld images.

Hiring for it

Visual and borescope inspection is among the QA/QC skills WELDK’s capabilities page lists. Ask candidates how they named and stored images on their last job and test their judgement with real images (QA/QC interview questions). Defects you will see in the images are explained in common orbital weld defects.

Frequently asked questions

Do welders take borescope images themselves?

On some sites welders or operators check their own welds, but the acceptance record is usually made by QA/QC. Your quality plan decides who may record acceptance.

Video or still images?

Either, if the owner accepts it. Stills are easier to review and file; video can show the full circumference. Agree the format before work starts.

Are borescope images needed for fitting welds inside tools?

That depends on the owner and on access. Where a weld cannot be borescoped after assembly, owners often rely on sample welds and the welder’s record; check the specification.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.