UHP piping · Screening

Questions that separate fab UHP pipers from general pipefitters

Ask about the details only UHP work teaches: how they cut and face tube without particles, how components stay bagged and capped until installation, how face-seal fittings are made up, what they prepare for a helium leak test, and how lines are labelled. General pipefitters answer in terms of fit-up and welding; UHP pipers answer in terms of cleanliness, components and testing.

Questions and strong answers
QuestionA strong answer mentions
How do you cut 316L EP tube?Tube cutter, facing to a square end with no inside burr, cleaning per spec; no saw chips inside
What do you do when a bagged component arrives?Keep it bagged until the point of use; check labels; cap ends
How do you make up a face-seal fitting?New gasket, clean sealing surfaces, manufacturer’s make-up instructions
What do you prepare for a helium leak test?Isolation, test connections, access to joints, records
How are lines labelled?Gas or chemical name, flow direction, line number per spec
What went wrong on a line you installed?A concrete example and what they changed

Listen for the method

Strong candidates describe steps in order and mention why each step matters. Vague answers about “following the procedure” without saying what it was are worth probing.

Follow the interview with a practical test.

Frequently asked questions

How many questions are enough?

Five or six well-chosen questions with follow-ups tell you more than a long list. Use the ones that match your scope.

Can we use these questions with an interpreter?

Yes. Brief the interpreter on the terms first, and ask the candidate to describe steps rather than answer yes or no.

Do strong answers replace a test?

No. They show knowledge; the practical test shows hands-on habits.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.