UHP piping · Testing

Running a practical test for a UHP piper

A useful UHP piper test takes about half a shift and covers four tasks: cut and face tube, bend to a drawing, make up a face-seal fitting, and handle bagged components cleanly throughout. Observe the method as closely as the result, and finish with a leak check of the assembly if your site has the equipment.

Test tasks

  1. Cut and face: two pieces of your tube to length, square and burr-free, cleaned as your specification requires.
  2. Bend: a short run with two bends to a sketch, checked for dimensions and ovality — only where your specification allows bent tube (many owners restrict bending of EP tube on specialty gas lines).
  3. Make up: a face-seal joint with a new gasket, following the manufacturer’s instructions.
  4. Handle: keep components bagged and ends capped until use, and label the assembly.
  5. Check: leak check of the assembly if equipment is available.
What to observe
ObserveGood signWarning sign
Tool useRight tool, steady methodSaw chips, rough ends
CleanlinessCaps on until use, clean glovesOpen ends on the bench
Fitting make-upNew gasket, sealing surfaces protectedReused gasket, scratched beads
MeasurementMeasures twice, checks against sketchGuesswork

If the candidate is in Korea

The same tasks can be watched on a continuous video with the candidate identified at the start, as with weld tests (testing a welder in Korea). Final acceptance happens on site under your procedures.

Frequently asked questions

Is a written test useful?

A short drawing or labelling question can help, but hands-on tasks show the habits that matter most in UHP work.

Should we test plastic fusion at the same time?

Only if the role includes it. Use the process and equipment your specification requires.

Who judges the test?

Your supervisor or QA person, against your procedures. WELDK does not run or judge tests.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.