Fab welding · Equipment

Switching orbital equipment brands: what a new hire needs to relearn

The welding knowledge carries over — joint preparation, purge, tungsten and reading coupons. What a new hire has to relearn on another brand is the controls: how schedules are built and stored, head set-up and tungsten positioning tools, clamp inserts, and how the machine records data. Plan supervised coupons on your equipment before production welds, whatever the candidate’s experience.

Carries over and needs relearning

Moving between orbital equipment brands
AreaCarries overNeeds relearning
Joint preparationCutting, facing, squareness, cleaning—
PurgePurge logic and oxygen checkingBrand-specific purge fittings or head gas paths
TungstenCondition and grindingPositioning gauges and arc gap setting for that head
SchedulesUnderstanding of levels, pulse and speedHow the machine builds, stores and locks schedules
Head and insertsHandling and careInsert sizes, clamp set-up, head clearance
RecordsWeld log disciplineMachine data output and how it links to your log

A short supervised start

  1. Walk through the power supply and one head with the site’s lead orbital welder or the equipment supplier.
  2. Weld coupons on the smallest and largest sizes in the scope.
  3. Review the coupons inside and outside against your specification.
  4. Confirm how the welder records schedules and welds on this machine.
  5. Start production when your QA procedure is satisfied.

In hiring

List the brand and head models in the requirement as a nice-to-have, not a must-have, unless your schedule has no time for supervised coupons (writing the requirement). In the test, use your own equipment where you can.

Frequently asked questions

Does a manufacturer training certificate replace your own coupons?

No. It shows training on that brand, not qualification to your procedure or current skill on your machines.

Can we use the candidate’s schedules from a previous job?

Use the schedules your procedures approve. Earlier schedules can be a starting point for development, but your QA process decides.

How many coupons are enough?

Your specification and QA manager decide. Cover at least the size range and any difficult access the welder will face.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.