Fab welding · Performance

When a new welder keeps failing: retrain, retest or replace

First find out whether the rejects share one cause. If they trace to set-up, equipment or unclear instructions, retrain and supervise. If the cause is hand skill or a lapse covered by your qualification rules, retest. Replace only when retraining and retesting have failed, and follow the employment contract and local law, because the welder is your employee.

Find the cause first

Reading a run of rejected welds
PatternLikely causeFirst step
Same fault every time, for example inside discolorationPurge set-up or habitWatch one full weld cycle; correct the routine
Faults only on one size or headEquipment set-up or scheduleCheck the schedule and head; supervised coupons
Faults started after a changeNew material heat, equipment or procedureCompare with welds before the change
Random faults across sizesSkill or attentionRetest to the WPS
Faults where instructions changedMisunderstood instructionExplain again in writing; ask the welder to explain back

Retrain, retest, replace

  1. Retrain: a short supervised period with a lead welder, focused on the cause found. Record what was covered.
  2. Retest: when your QA procedure or code rules require it, or when retraining did not fix the pattern.
  3. Reassign: sometimes the welder is solid on one type of work and not another — move them before replacing.
  4. Replace: only after the steps above, following the contract, local employment law and the visa conditions that apply.

Language is often part of it

New hires working in a second language may follow an instruction as they understood it. Before deciding it is a skill problem, check that the specification and any changes were explained clearly (onboarding).

What WELDK does and does not do

The welder is your employee, so performance decisions are yours. WELDK does not guarantee test results or the success of a hire.

Frequently asked questions

How long should retraining last?

Long enough to show whether the pattern is fixed on the work that failed. Agree a short, defined period and review the results.

Should we stop the welder from production during retraining?

Your QA procedure decides. Many sites move the welder to supervised or lower-risk work until the cause is fixed.

Does a replacement come from WELDK automatically?

No. Any further search is a new request under written terms; WELDK does not guarantee replacements.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.