UHP piping · Quality

Common UHP installation faults and how to prevent them

Most UHP rework traces to a few faults: leaking fittings, contamination from open ends or cutting, wrong or mislabelled components, poor supports that stress joints, and records that do not match the line. Each has a preventing habit, so brief new crews on the habits and check them in the first weeks.

Faults and preventing habits
FaultCommon causeHabit that prevents it
Leaking face-seal fittingReused gasket, damaged bead, wrong make-upNew gasket, protect beads, follow instructions
Particles in the lineCutting debris, open endsProper cutting and facing, capping
Wrong componentSimilar-looking parts, missing labelsCheck part number and label before installation
Stressed jointsMissing or misplaced supportsSupport as the drawing shows before final make-up
Records mismatchJoint numbers not updatedUpdate records at the time of work

Check in the first weeks

  • Walk a recently finished section with the crew and point out what is right and wrong.
  • Review the first leak-test results by crew.
  • Spot-check component labels against the records.

For fittings see face-seal fitting mistakes.

Frequently asked questions

Which fault costs most?

Contamination found at certification, because it can mean reopening and retesting whole sections.

Should faults be tracked per person?

Track them per crew and per cause; that shows whether the problem is a habit or a person.

Do these faults mean the crew is inexperienced?

Not always. Site-specific rules and components differ; a clear briefing prevents many of them.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.