UHP piping · Contamination

Contamination found in a new line: what the piping crew does next

When certification finds contamination, stop and report it, keep the section isolated, and help QA find the source before reworking anything. The crew’s part is to open, inspect and replace or clean components as the approved rework plan says, then reassemble and support retesting. Improvised cleaning can make the problem worse.

Steps

  1. Report to the supervisor and QA; keep the section isolated.
  2. Help locate the source: recent joints, open-ended periods, components installed from damaged bags.
  3. Follow the rework plan the owner or QA approves.
  4. Reassemble with new gaskets and clean components.
  5. Retest and recertify as the specification requires.
Likely sources
FindingPossible source
ParticlesCutting debris, open ends, damaged component packaging
MoistureLine left open, poor purge
OxygenLeak, poor purge
Discoloured welds found on inspectionWeld purge problems (weld defects)

Learn from it

Brief the crew on the cause and change the routine that allowed it, for example capping rules or cutting methods (bagging and capping).

Frequently asked questions

Can the crew blow out a line to clear particles?

Only if the approved rework plan allows it. Uncontrolled flushing can spread contamination.

Who pays for rework?

That depends on your contracts. Within your company, it is a cost to track like any rework.

Is one contamination finding a reason to replace a worker?

Not by itself. Find the cause; often it is a routine or a supervision gap.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.