Questions and good answers
| Question | A good answer includes |
|---|---|
| Tell me about your last project. | Owner project, system, contractor, months on site |
| What material and sizes did you weld? | Grade, outside diameters or pipe sizes, wall thickness |
| Which equipment did you use? | Power supply and head models, or TIG machine type |
| How did you set up the purge? | Gas, flow, time, oxygen check before the arc |
| What happened when a coupon failed? | The cause found, the change made, who approved it |
| Who checked your welds? | QA/QC, borescope or other tests, how often |
| How did you record your welds? | Weld log entries, welder ID, heat numbers |
| What do you do if a permit is not ready? | Stop and wait; ask the foreman; do not start hot work |
| Explain this WPS value in your words. | A correct explanation, not only yes or no |
Fault questions
Show a photo of a weld with a common fault, such as inside discoloration or lack of penetration, and ask what caused it. See common orbital weld defects.
Interview tips
- Ask one short question at a time.
- Ask the candidate to explain, not to confirm.
- Use the same questions for every candidate, so you can compare.
- Keep the test for hand skill; the interview is for knowledge and fit.
For timing and interpreters, see interviewing a welder in Korea.