Fab welding · Scope

Manual TIG or orbital welder: which does your fab scope need?

Hire orbital welders for small-diameter high-purity tube — 316L EP or BA gas and chemical distribution — where the owner specification calls for machine welds with a recorded weld schedule. Hire manual TIG welders for process pipe, carbon steel, larger diameters, tie-ins and joints an orbital head cannot reach. Most fab mechanical scopes need both, in a ratio set by how much of the work is tube versus pipe.

Split the scope by line type

Which trade usually welds which line (check your own specification)
Scope itemUsual tradeWhy
Bulk and specialty gas distribution, 316L EP/BA tubeOrbital welderRepeatable autogenous welds, low heat input, inside-surface finish matters, owner specs usually require machine welding and weld logs
Gas cabinet, VMB/VMP and tool hook-up tubeOrbital welderSame tube class; tight spaces need compact heads and careful setup
Vacuum and exhaust lines in stainlessOrbital or manual TIGDepends on diameter, wall and specification; larger ducts are often manual
Process cooling water, utility and carbon steel pipeManual TIG (often with other processes for fill and cap)Larger diameters and thicker walls, all-position hand welding
Battery plant solvent, slurry and utility stainless pipeManual TIGLarger pipe is often welded by hand (orbital pipe heads exist but are less common on these scopes); root quality and back-purge matter
Tie-ins, repairs and field adjustmentsManual TIGLimited clearance, irregular fit-up, no time for head setup
Plastic chemical and UPW lines (PVDF, PFA, PP)NeitherJoined by plastic fusion or flare and mechanical fittings, by a different trade

Why the two are separate hires

An orbital welder’s skill is mostly in preparation and control: squaring and facing tube ends, choosing and grinding tungsten, setting the head, developing or following a weld schedule, controlling purge and reading coupons. A manual TIG welder’s skill is in the hands: torch angle, filler feed and travel in every position. Someone excellent at one is not automatically competent at the other, which is why codes qualify them differently (see welder or welding operator).

Questions that settle the ratio

  • How many tube welds versus pipe welds are in the work packages, and in which sizes?
  • Does the owner specification require orbital welding for all high-purity tube, or only above a certain size?
  • Which orbital equipment brand and head models will the site use? Experience on the same equipment shortens setup time.
  • Will the crew prefabricate spools in a shop area, or weld mostly in place? In-place work needs more manual capacity.
  • Who develops weld schedules — your QA team, the equipment supplier or the lead orbital welder?

When one person can cover both

Some technicians have done both kinds of work. Treat that as two separate claims: ask for the tube sizes and equipment they used, the pipe sizes and positions they welded, and test each one you plan to use them for. On a WELDK profile, each claim is marked as candidate-provided, reviewed by staff or employer-tested (how to read a profile).

Frequently asked questions

Is orbital welding required for all semiconductor gas lines?

It depends on the owner’s specification. Machine orbital welding is the common practice for 316L EP and BA gas tube because it is repeatable and recorded, but your specification sets which lines and sizes require it.

Can a manual TIG welder learn orbital welding on site?

Some do, but it takes training on the specific equipment and supervised coupon welds. On a schedule-driven fab project it is usually safer to hire people who already have orbital experience and test them on your equipment.

Do battery plants need orbital welders?

Usually fewer than a semiconductor fab, because more of the piping is larger stainless and carbon steel pipe that is often welded by hand. Check how much small-diameter clean tube is in your scope.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.