Fab welding · Materials

Stainless, carbon steel or duplex: matching TIG welders to your pipe materials

Match manual TIG welders to the hardest material and position they will weld, not the most common one. Austenitic stainless pipe needs back-purge discipline and heat control; carbon steel process pipe often combines a TIG root with other processes for fill and cap; duplex stainless needs tight heat input and interpass control. Ask which of these the candidate welded recently and test the most demanding one.

What changes by material

Manual TIG on common fab and battery plant pipe materials (your WPS sets the limits)
MaterialTypical use on siteWhat separates good weldersWhat to test
Austenitic stainless (304L, 316L)Process cooling, exhaust, chemical and solvent linesBack-purge set-up, low heat tint, clean root without sugaringRoot on your smallest stainless pipe in a fixed position
Carbon steelUtilities, fire protection, structural attachmentsRoot penetration and tie-ins, fit-up on larger diametersRoot and hot pass to your WPS; fill and cap if they will do it
Duplex stainlessSome aggressive-service linesHeat input and interpass control, purge, filler choice per WPSOnly if your scope has it; follow the WPS limits closely
Dissimilar jointsStainless to carbon steel at interfacesFiller selection per WPS, controlled dilutionOnly where the scope includes them

Positions and diameters matter as much as material

A welder who has welded 316L pipe on the bench may struggle with the same pipe fixed overhead between a rack and a ceiling. Ask for positions and diameter ranges welded in the last projects, and match your test to the worst realistic case. Qualification ranges for positions and diameters are set by the code and your WPS (see how qualification works).

Questions to ask

  • Which materials did you weld on your last two projects, and in which sizes and positions?
  • How did you set up the back-purge on a long stainless spool?
  • What did your WPS say about interpass temperature, and how did you check it?
  • Did you weld only the root, or root to cap?

Where your QA team decides

Filler metals, heat input, interpass limits and acceptance criteria are set by your welding procedures and the code you build to. Use them as the reference for both the interview and the test, and give them to the candidate before the test.

Frequently asked questions

Is a stainless TIG welder automatically good on carbon steel?

Not automatically. Carbon steel roots, larger diameters and tie-ins need their own practice. Test the material and position you will actually use.

Do we need duplex experience?

Only if your scope includes duplex lines. If it does, make it a must-have and test it to your WPS, because heat control is critical.

Should the welder bring their own filler metal?

No. Use the filler your WPS specifies, supplied and controlled by the site, so traceability is kept.

Have a fab scope that needs these trades?

Requests are in preview: you can fill in the request form, but it does not submit yet. Email WELDK with your roles, site country and start window.