How continuity works
| Situation | Effect | What QA/QC records |
|---|---|---|
| Person welds regularly with the process | Qualification stays in effect | Dated evidence of welding with that process, such as weld log entries |
| Six months or more without welding with that process | Qualification for that process expires | The gap, and the date it expired |
| Specific reason to question ability | Qualification supporting that work can be revoked | The reason, the decision, who made it |
| Expired qualification | Section IX describes how it can be renewed | The renewal test and its result |
Continuity is tracked per process, so a person can be current for one process and not another. Your QA manager confirms which version of the rules applies, since code editions change, and whether the owner adds stricter rules.
Why new hires need attention
- A new hire’s continuity record on your project starts with the qualification you make. Earlier employers’ records are not your continuity evidence.
- A gap between the end of the last job, travel and the site start can be long; plan the qualification date close to the start of production welding.
- Long waits for permits or access after qualification can run the clock down without anyone noticing.
- Moving a welder from orbital to manual work, or the reverse, may mean a different qualification and its own continuity.
Keep in mind that the qualification register and the weld log must agree. If the log shows a person welding with a process on a date when the register says their qualification had expired, that is a finding in itself, regardless of how good the weld was.
Tracking it
- Keep a qualification register: person, process, qualification date, ranges, last date welded.
- Update the last-welded date from the weld log, not from memory.
- Flag anyone approaching the limit and either assign them work with that process or plan renewal.
- Check the register before a person is assigned to a weld, as part of your start-of-shift check.
Make the register visible to the foreman as well as QA/QC. The foreman assigns work, and a simple status column (current, approaching the limit, expired) stops a person being sent to weld with a process they are no longer qualified for. When a welder is moved between work areas or crews, the register goes with the assignment decision.
Revocation is a code decision, not a performance review
Revocation is about a specific reason to question whether the person can make welds that meet the requirement, for the work in question. It is separate from how you measure the crew’s quality (reject rate tracking) and from the employment decision about a welder who keeps failing (retrain, retest or replace). Your QA manager makes the code decision and records it.