How an orbital welder works
- Preparation. The tube ends are cut square and faced, then cleaned.
- Fit-up. The ends are clamped in the weld head so they meet without gap or misalignment.
- Purge. Argon flows inside the tube (and inside an enclosed head) to keep oxygen away from the weld.
- Weld. The power supply runs the schedule: the electrode rotates around the joint while current changes by sector.
- Check. The weld is inspected outside and, on high-purity lines, inside with a borescope.
Where it is used
| Industry | Typical lines | Why orbital |
|---|---|---|
| Semiconductor fabs | Specialty and bulk gas, some chemical lines, tool hook-up | Clean, smooth inside surface and repeatability |
| Pharma and biotech | Process and clean utilities tube | Hygienic inside surface and documentation |
| Battery plants | Some gas and process tube | Where the specification calls for it |
| Power and process plants | Some pipe with open heads and filler wire | Productivity and consistency on repeated joints |
What the welder does
The machine does not replace skill. An orbital welder prepares the tube, sets up the head, selects or adjusts the schedule, controls the purge, makes test coupons, reads the result and keeps the weld log. Most quality problems come from preparation and purge, not from the machine (common orbital weld faults).
When your project needs orbital welders
- The owner specification calls for orbital welding on high-purity tube, often with criteria based on SEMI F78/F81.
- There are many repeated welds on the same tube sizes.
- Inside-surface criteria will be checked with a borescope.
- Otherwise, manual TIG welders may be the better hire (manual TIG or orbital).